Quell QPI9010 Manual page 8

0475-7214-06_QPI9010(130417):_
Installation
Mounting
When mounting
in a hallway, the
"A" line should
be parallel with
the hallway.
REMOVABLE
CAUTION: THIS UNIT IS SEALED. THE COVER IS NOT
REMOVABLE!
1.Remove the mounting plate from the back of the alarm by
holding the mounting plate and twisting the alarm anti-clock-
wise in the direction indicated by the "OFF" arrow on the
alarm cover.
2.To ensure aesthetic alignment of the alarm with the hallway or
wall, the "A" line on the mounting plate should be parallel
with the hallway when ceiling mounting or horizontal when
wall mounting.
3.After selecting the proper smoke alarm location as described
previously attach the mounting plate to the ceiling as shown in
Figure 2B. For wall mounting see Figure 2A and Figure 3.
Place the mounting plate on the wall. Be sure the "A" line is
horizontal (parallel to the floor). Use the screws and anchors
provided to secure the mounting plate (use 3/16" drill bit for
anchor holes).
Remove
Figure 3
2015.5.22
When wall
mounting, the
"A" line should
A A
be horizontal.
Alignment Marks
Install
2:12 PM Page
7