Quell QPI9010 Manual page 10

0475-7214-06_QPI9010(130417):_
Installation
TAMPER RESIST FEATURE:
To make your smoke alarm tamper resistant, a tamper
resist feature has been provided.
A
Posts
To activate this feature you must break out the four tamper
resist blocks on the mounting plate (see Figure 5). Use a small
screw driver or pliers.
The tamper resist feature will deter children and others from
removing the alarm from the mounting plate. Note: To remove
the alarm from the mounting plate when the tamper resist tab is
engaged, press down on the tamper resist tab and rotate the
alarm anti-clockwise in the direction indicated by the "OFF"
arrow on the cover of the alarm (see Figure 5).
After installation, test your alarm by depressing and holding
down the test button for a minimum of 5 seconds or until alarm
sounds. CAUTION: Due to the loudness (85 Decibels) of the
alarm, always stand an arms length away from the unit when
testing.
2015.5.22
A
FIGURE 5
2:12 PM Page
9