Baxi ECO4S 24 F Operating And Installation Instruction page 20

To set the boiler parameters press the (
active, the letters "F01" will appear on the display, alternating with the value of the parameter shown.
Changing the parameters
+/–
• Press the ( ) buttons to scroll through the parameters;
+/–
• Press the ( ) buttons to change each parameter value;
• Press the button ( ) to save changes, the display shows "MEM";
i
• Press the button ( ) to leave the function without saving, the display shows "ESC";
Description of parameters
Type of boiler
F01
10 = sealed chamber - 20 = atmospheric chamber
Gas used
F02
00 = NATURAL (METHANE) - 01 = LPG
Hydraulic system
00 = instant appliance
F03
03 = appliance with external storage boiler
04 = appliance for heating only
Setting programmable relays 1 and 2
F04/ F05 (See SERVICE instructions)
00 = no associated function
Maximum temperature setpoint setting (°C)
F06
00 = 85°C - 01 = 45°C
F07 Configuration DHW priority input
F08 (*) Max heating power (0-100%)
F09 Max DHW power (0-100%)
F10 Min heating power (0-100%)
Waiting time in heating before a new ignition
F11
(00-10 minutes) - 00=10 seconds
F12 Diagnostics (See SERVICE Instructions)
Type of exchanger
F13 00 = 270 mm
01 = 225 mm
Testing the correct position of the DHW probe
F14 00 = Disable
01 = Enable
F15
factory setting
(*) For 18 F model the value of F08 parameter shown in the table is indicative. The value of F08 parameter has to
correspond to a burner pressure, with the boiler operating at CH max heat output, as shown in the table below.
If the burner pressure, with the boiler operating at CH max heat output, is different from the specified value, change the
value of F08 parameter.
INSTRUCTIONS FOR FITTERS
W Z D d Z^ ^ dd/E'
– –
) and ( ) buttons together for at least 6 seconds. When the function is
24 F
10
00
100
01
G20
6,8 ± 0,3 mbar 17,2 ± 0,3 mbar
20
Factory settings
1. 24 F 24
10 20
00 o 01
04 00
00
00
00
100 100
100
00
03
--
01 00
00
00
G31
18 F 10 F
10 10
00 00
66 (72 GPL) (*) 0
01 01
7222863.02 - en