Makel MSA-CM Series User Manual page 35

Each of the scenes can be configured to a specific action that may, or may not, depending on the
installation settings, change at run time. In case changes can be made after configuration with ETS, those
changes are persistent, which means, even after a power dow followed by a power restore the changes
will be kept. However, restoring the scenes to the configuration time settings is possible via "Restore
Scenes" CO; this process will restore all the scenes form all the channels to its setting of ETS
configurations deployment.
Scenes configuration page in its defaults can be seen in Figure 13 and detailed information in Table 8.
Figure 13: Shutter and Blinds' Channel Scenes configuration page.
Table 8: Parameters for Shutter and Blinds' Channel Scenes configuration.
Parameter
Scene learn allowed?
Output status for scene [1...32]
19 Shutter position
20
Blinds position
19 Visible if "Output status for scene[1...32]" is "Position".
20 Visible if "Output status for scene[1...32]" is "Position" and "O[x]-[x+1]: General" → "Control also
Blinds?" is "Yes".
User's Manual
Description
Defines if the device will recognise the
scene "learn" command and memorise
its current status to the respective
scene.
Defines the channel's behaviour for a
certain scene number.
Defines the shutter's position for the
corresponding scene.
Defines the Blinds' position for the
corresponding scene.
4 Detailed Functions Description
Values
Possible values:
No
*Yes
Possible values:
*Not involved
Close
Open
Position
Min: 0%
Max: 100%
Default: 0%
Min: 0°
Max: 180°
Default: 0°
Page 35