Makel MSA-CM Series User Manual page 23

In case the parameter "Logic input function" is set to any other logic operation (AND, OR, XOR,
NAND, NOR, XNOR) to the "On / Off" CO is applied the selected logic operation with the logic
input CO and the "On / Off" function is processed according to the resulted value. In Figure 5 is presented
a possible scenario when "On / Off" uses "Delayed On" combined with logic input function AND.
Figure 5: "On / Off" configured to "Delayed On" and using logic "AND".
d) Channel status after system start / power recover
The behavior of each output of the device when it's started, for example after a power failure, can be
defined by setting the parameter "Status after system start" to the desired value. If the parameter is set
to "Maintain", at power failure the device tries to save its current output status and restores it at power
restore; it can be defined the channel to turn "On" or "Off" or to set to a defined scene.
e) Channel output contact type
The definition of the "On" and "Off" position of the channel's switch is done in the parameter "Output
contact type".
f) Jamming
The directly related COs are:
[input] "Jamming": control of the jamming;
User's Manual
4 Detailed Functions Description
Page 23