Table of Contents
Advertisement
3
GETTING STARTED
3.1
Connecting for the first time
After connecting the MSAxxyy/CM device for the first time to the KNX/EIB bus, the user will see the
LEDs opening and closing preforming a circular sequence. This behavior means that the device hasn't
been loaded with a valid ETS™' application yet. The same behavior may be observed when an invalid
application is loaded into the device.
While signalising no application loaded, the device can be manually operated by pressing the Manual
Mode button and by pressing any of the channels' buttons. However, in this mode a couple of channels (1
and 2, 3 and 4, 5 and 6, ...) cannot not be both "On" at the same time. This is a characteristic of the
device for avoiding unintended short-circuit of shutters and blinds devices; if one of the relays from the
pair is closed and the other is asked to close, the device will first open the first and then proceed to close
the one that as been requested
3.2
Downloading application with ETS™
If it's the first time that the device will be programmed, you must define the Individual Address via
ETS™ interface. You must also press the programming button on the device for allowing ETS™ to
identify the target device. You will know that the device is in programming mode when the programming
LED turns on. During programming process the programming LED and the programming mode will
automatically turn off.
The Individual Address is normally written once, however if it's necessary to re-write the Individual
Address, the programming button must be pressed.
Once the device has its Individual Address, the device can be configured according to the project needs
using ETS™ application, selecting "Download Application".
2
The minimum gap (both remain "Off" before turning "On" the requested channel) is of 40ms.
User's Manual
2
.
3 Getting Started
Page 11
Advertisement
Table of Contents
