O[X]: Scenes - Makel MSA-CM Series User Manual

Figure 7: Channel's Measurements configuration page.
Table 5: Parameters in Channel's General configurations page.
Parameter
Use working duration counter?
16
Limit to send alert message
(hours)
16
Output status to measure
16
Counter direction
The parameter "Limit to send alert message (hours)" defines the limit after which a message must be
issued informing that the limit has been reached. The parameter "Output status to measure" selects
which is the output status that must be measured as working.

4.2.3 O[x]: Scenes

The related COs are:
[input] "Scene Control": sets a scene or requests learn;
All the Channels have available from "Scene 1" to "Scene 32" for configuration. Each of the scenes can
be configured to a specific action that may, or may not, depending on the installation settings, change at
run time. In case changes can be made after configuration with ETS, those changes are persistent, which
16 Visible if "Use working duration counter?" set to "Yes."
User's Manual
Description
Selects if working time counter is to be
used for the channel.
The amount of time after which a
message must be sent via "Working
t. limit reached Ind." CO.
Defines which is the channel status to be
measured.
Defines if the counter must count from 0
to Limit or from Limit to 0.
4 Detailed Functions Description
Values
Possible values:
*No
Yes
Min: 0h
Max: 500000h
Default: 1000h
Possible values:
*On
Off
Possible values:
*Increment
Decrement
Page 26