Security I/O Wiring; Door Terminal Associations - Honeywell SEC-H-600 Installation Instructions Manual

SECURITY I/O WIRING

Security I/O wiring is covered in the following subsections:
• "Door Terminal Associations," page 15
• "Reader Input," page 17
• "Supervised Input," page 18
• "Relay Output," page 20
• "Digital Input," page 22

Door Terminal Associations

The SEC-H-600 controller provides access control for two doors. For each door, the controller allocates:
• One Reader Input (for a Wiegand-type, 12V reader)
• Two Supervised Inputs: one for door switch monitor, one for REX (request-to-exit)
• One Relay Output: for door strike control.
A default convention is used for the logical association between reader inputs, supervised inputs, and relay outputs for each door,
as shown in Table 4 below.
Table 4. Door mapping to security I/O terminal points.
Door Reader Input
Door 1 Card Reader 1
Door 2 Card Reader 2
NOTE: Terminal associations shown in Table 4 also apply if wiring a SEC-H-R2R (2 reader) expansion module.
See the following sections below for more details:
• Example Door 1 Wiring
• Other Terminal Associations
Supervised Input Terminals (with GND)
Door Switch Request to Exit
Monitor
SI1 SI2
SI3 SI4
Relay Output Terminals
(REX) Door Lock
1 (C1 and NO1, or NC1)
2 (C2 and NO2, or NC2)
15
SEC-H-600 SECURITY CONTROLLER
95-7759-07