Certifications - Honeywell SEC-H-600 Installation Instructions Manual

SEC-H-600 SECURITY CONTROLLER

CERTIFICATIONS

Installation :
The control units and accessories are intended to be installed in accordance with the following:
1. The National Electrical Code, ANSI/NFPA 70.
2. Canadian Electrical Code, Part I.
3. Local Authority having Jurisdiction.
Underwriters Laboratories, Inc (UL) / Canadian Standards Association (CSA)
When installed in accordance with UL requirements, this equipment meets the following UL listing:
• UL 294
• CSA No. C22.2 No. 205
See the "UL Requirements," page 28, for more details.
Federal Communications Commission (FCC)
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause interference with radio communications. It has been tested and found to comply with the limits for
a Class A computing device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection
against such interference when operated in a commercial environment. Operation of this equipment in a residential area may
cause interference, in which case, users at their own expense will be required to take whatever measures may be required to
correct the interference. Any unauthorized modification of this equipment may result in the revocation of the owner's authority to
continue its operation.
Canadian Department of Communications (DOC)
• This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
• Cet appareil numerique de la classe A respecte toutes les exigencies du Reglement sur le material broilleur du Canada.
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Toronto, Ontario M1V 4Z9
customer.honeywell.com
Access Control System Units
Signal Equipment
® U.S. Registered Trademark
© 2010 Honeywell International Inc.
95-7759—07
Printed in U.S.A.
M.S. Rev. 02-10