Material And Tools Required; Precautions; Safety Precautions; Static Discharge Precautions - Honeywell SEC-H-600 Installation Instructions Manual

Material and Tools Required

The following supplies and tools are required for installation:
• Medium or large sized WEBs-AX Security Enclosure, model SEC-ENC-H-1 or SEC-ENC-H-2. See "WEBs-AX Security
Enclosure," page 4, for more details.
• Suitable tools and supplies for mounting enclosure, SEC-H-600 model of Security Controller and expansion modules, and for
making all wiring terminations.

PRECAUTIONS

This document uses the following warning and caution conventions:
CAUTION
Cautions remind the reader to be careful. They alert readers to situations where there is a chance that the reader
might perform an action that cannot be undone, might receive unexpected results, or might lose data. Cautions
contain an explanation of why the action is potentially problematic.
WARNING
Warnings alert the reader to proceed with extreme care. They alert readers to situations where there is a chance
that the reader might do something that can result in personal injury or equipment damage. Warnings contain an
explanation of why the action is potentially dangerous.

Safety Precautions

The following items are warnings of a general nature relating to the installation and start-up of the Security Controller. Be sure to
heed these warnings to prevent personal injury or equipment damage.
WARNING
The circuit powering the controller is from 120 to 240Vac at 50/60 Hz. Disconnect power before installation or
servicing to prevent electrical shock or equipment damage.
Make all connections in accordance with national and local electrical codes. Use copper conductors only.
To reduce the risk of fire or electrical shock, install in a controlled environment relatively free of contaminants.
This device is only intended for use as a monitoring and control device. To prevent data loss or equipment
damage, do not use it for any other purpose.

Static Discharge Precautions

Static charges produce voltages high enough to damage electronic components. The microprocessors and associated circuitry
within a Security Controller are sensitive to static discharge. Follow these precautions when installing, servicing, or operating the
system:
CAUTION
Work in a static-free area.
Discharge any static electricity you may have accumulated. Discharge static electricity by touching a known,
securely grounded object.
Do not handle the printed circuit board (PCB) without proper protection against static discharge. Use a wrist
strap when handling PCBs. The wrist strap clamp must be secured to earth ground.
SEC-H-600 SECURITY CONTROLLER
9 95-7759—07