Board Layout; About Screw Terminal Connectors - Honeywell SEC-H-600 Installation Instructions Manual

SEC-H-600 SECURITY CONTROLLER

BOARD LAYOUT

Figure 4 shows the location of LEDs, option slots, and other features of the SEC-H-600 Security Controller, with cover removed.
For a side view of communications ports and other features, see Fig. 15 on page 26.
Reader Input 2
(Wiegand 12V type)
Option Slot 2 Area
NiMH battery
pack Connector
(see Fig. 15 on
page 26)
6 Pin End
Connector
(Expansion
Modules)
Option Slot
Connectors
Option Slot 1 Area
Earth Ground
Connector
Lug
Unsupervised Digital
Inputs (1—3)
One 4-position connector

About Screw Terminal Connectors

Screw-terminal connectors are shipped loose in a separate hardware bag. If desired, you can make wiring terminations to
connectors before installing on the Security Controller circuit board pins. Please note the following:
• When you install a connector onto the board pins, terminal labels (on the circuit board) are covered.
• Once installed, removal of larger connectors (readers, relay outputs) may be difficult, especially if wiring has been landed.
Here, removal is recommended only if replacing the device.
In general, it may be easiest to wire to loose connectors (held next to pins), then install them after completing.
95-7759—07
Fig. 4. Security Controller (SEC-H-600) board layout details.
each has one
Reader Input 1
7-position
(Wiegand 12V type)
connector
Security
Controller
NiMH
Backup
Battery and
Bracket
Digital Supervised Inputs (1—6)
Three 3-position connectors
Form-C Relay Outputs 1—4
Two 6-position connectors
Status LEDs (visible with cover on)
LAN1 BEAT STATUS
LAN2
Primary
Ethernet
(RJ-45)
LAN1
RS-232
(DB-9)
COM1
12
LEDs for
relay
outputs
Mode Jumper
(for serial shell
access)
6 Pin End
Connector
(Expansion
Modules)
includes
RS-485
LEDs for COM1
(RS-232) and
COM2 (RS-485)
USB Port
(top board)
Future Use
For External 12Vdc SLA
15Vdc Supply Backup Battery
(one 4-position connector)