Troubleshooting - Carestream DRX-Revolution Hardware Manual

7

Troubleshooting

Problem
The system does not start
up.
During startup, one of the
tasks in the Startup screen
does not start.
The Operator Console
powers up successfully, but
reports a blocking error.
The Operator Console
powers up successfully, but
the application does not
start.
You cannot log on.
Unable to set parameters
due to a failed
communications link
Faulty tape measure
Issues with the exposure
switch
The arm will not hold
position and sags out of
position.
Batteries fail to charge
AF0118 | 2018-03-27
Recommended Action
•
Check the battery level indicators.
•
Make sure all applicable switches on the system are on.
•
If the problem persists, contact your authorized Service Provider.
•
Power down the system and power up the system again.
•
If the failure occurs again, contact your authorized Service
Provider.
•
Power down the system and power up the system again.
•
If the blocking error occurs again, contact your authorized
Service Provider.
•
Power down the system and power up the system again.
•
If the problem persists, contact your authorized Service Provider.
•
Make sure you are using the correct login and password. Note
that passwords are case-sensitive.
•
Check with your System Administrator or Key Operator.
•
If the problem persists, contact your authorized Service Provider.
•
Power down the system and power up the system again.
•
If problem persists, contact your authorized Service Provider.
Contact your authorized service provider.
Contact your authorized service provider.
If the problem persists, contact your authorized service provider.
•
Power down the system and power up the system again.
•
If problem persists, contact your authorized Service Provider.
7-1