Cleaning The Arm; System Maintenance - Carestream DRX-Revolution Hardware Manual

Maintenance and Safety Information

Cleaning the Arm

Handle the painted arm assembly with care to avoid striking any object, which may
chip the paint.
You can clean the arm using any of these methods:
Use a battery-powered vacuum with a soft nozzle to remove the dust and dirt. Pay
particular attention to corners and side grooves, where build-up of dirt and residue can
occur.
Wipe the surface with a soft, lint-free cloth dampened with warm water and a mild
liquid detergent. Tri sodium phosphate (TSP) is made specifically to remove grease and
grime from painted surfaces without harming the finish.
Use a solution of 70% isopropyl alcohol on a clean, soft cloth.

System Maintenance

Caution
Do not attempt mechanical or electrical repair of the System. Contact your authorized Service
Provider if any unit does not perform to your satisfaction.
Avoid performance issues and unplanned downtime with regularly scheduled
inspection, calibration, and preventive maintenance checks. The equipment must be
maintained in good operating order at all times to provide safe conditions for
operating personnel and patients. It must also be maintained to prevent possible loss
of patient or image data. To ensure continued safe performance of X-ray equipment, it
is the owner's responsibility to supply or arrange for a periodic maintenance program.
Important
After installation, perform maintenance on the system per the schedule.
Circuit diagrams and other specific instruction required to service and repair this unit is provided
with Manufacturer's service training.
Important
If the unit has been out of operation for over 6 months, contact your authorized Service
provider to recommission the system.
Caution
There are no parts of this equipment that can be serviced or maintained while in use with the
patient.
AF0118 | 2018-03-27 5-5