Quantum StorNext QM1200 Replacing Manual page 6

StorNext QM1200/QS1200/QS2400 Expansion Unit - Replacing a Power-Fan Canister
Figure 4 Removing a Power-Fan Canister
Installing the Power-Fan Canister
1. Slide the replacement power-fan canister all the way into the expansion unit. Rotate the latches towards the
center to lock the power-fan canister into place.
2. Make sure that the Power switch on the replacement power-fan canister is turned off, and plug in the power cord.
3. Attach the plastic strain relief to the power cord, and make sure that it fits snugly up against the power-fan
canister.
4. Turn on the Power switch on the replacement power-fan canister.
5. Check the Power-Fan Input AC Power LED, and the Power-Fan Service Action Required LED on the new power-fan
canister
6. Based on the LED status, perform one of these actions:
The Power-Fan Input AC Power LED are on and the Power-Fan Service Action Required LED is off – Go to
—
step 8.
The Power-Fan Output DC Power LED and the Power-Fan Input AC Power LED are off or the Power-Fan
—
Service Action Required LED is on – Check that the power-fan canister is installed correctly. Reinstall the
power-fan canister. Go to step 7.
7. Did this action correct the problem?
Yes – Go to step 8.
—
No – If the problem has not been resolved, contact your Customer and Technical Support representative.
—
8. Using the LEDs and the storage management software, check the status of all of the trays in the storage array.
9. Does any component have a Needs Attention status?
(Figure 2 on page 2).
Quantum Corporation
- 4 -
April 2015