Quantum StorNext QM1200 Replacing Manual page 5

StorNext QM1200/QS1200/QS2400 Expansion Unit - Replacing a Power-Fan Canister
[trayID] is the identifier of the expansion unit that contains the power-fan canister that you want to
—
replace. Drive tray ID values are 0 to 99. Be sure to type the square brackets around the identifier.
[left|right] is the identifier of the power-fan canister you want to replace. Valid values are left or
—
right. Be sure to type the square brackets around the value.
b. On the GUI, click on the image of the tray that contains the power-fan canister you want to replace. From the
Array Management Window toolbar, select Hardware >> Prepare for Removal.
4. Put on antistatic protection.
5. Unpack the new power-fan canister.
a. Set the new power-fan canister on a flat, static-free surface near the expansion unit.
b. Save all packing materials in case you need to return the power-fan canister.
Removing the Power-Fan Canister
1. Turn off the Power switch on the power-fan canister that has failed
Figure 3 AC Power Switch on the Drive Tray
2. Remove the plastic strain relief from the power cord.
3. Unplug the power cord from the failed A power-fan canister.
4. Remove the power-fan canister from the expansion unit
a. Rotate the latches outward to disengage the power-fan canister.
b. Use the latches as handles to pull the power-fan canister out of the expansion unit.
NOTE While removing the power-fan canister, you might notice an increase in fan speed. The fan speed returns to normal after you
have replaced the power-fan canister.
1. AC Power Switch
(Figure 4
Quantum Corporation
- 3 -
(Figure 3).
on page 4).
April 2015