High Beams; Flash-To-Pass; Automatic Lighting; Parking Lighting - Jeep CHEROKEE 2017 User Manual

High Beams

Push the multifunction lever toward the in-
strument panel to switch the headlights to
high beams. Pulling the multifunction back
toward the steering wheel will turn the low
beams back on, or shut the high beams off.

Flash-To-Pass

You can signal another vehicle with your
headlights by lightly pulling the multifunc-
tion lever toward you. This will cause the
headlights to turn on at high beam and re-
main on until the lever is released.

Automatic Lighting

The Automatic High Beams system provides
increased forward lighting at night by auto-
mating high beam control through the use of
a digital camera mounted above the inside
rearview mirror. This camera detects vehicle
specific light and automatically switches
from high beams to low beams until the
approaching vehicle is out of view. This fea-
ture is programmable through the Uconnect
system. Refer to "Uconnect Settings" in
"Multimedia" in the Owner's Manual on
www.mopar.eu/owner for further details.
The headlight switch is located on the instru-
ment panel to the left of the steering wheel.
When set to AUTO, the system automatically
turns the headlights on or off based on ambi-
ent light levels.

Parking Lighting

To operate the parking lighting, the ignition
must be in the OFF position. Rotate the
headlight switch counterclockwise to the "P"
position. Then move the multifunction lever
up or down to turn on the left or right side
parking lights.

Headlight Delay

This feature provides the safety of headlight
illumination for up to 90 seconds (program-
mable) when leaving your vehicle in an unlit
area.
To activate the delay feature, place the igni-
tion in the OFF position while the headlights
are still on. Then, turn off the headlights
within 45 seconds. The delay interval begins
when the headlight switch is turned off.
If you turn the headlights or parking lights on,
or place the ignition in ACC or RUN, the
system will cancel the delay.
If you turn the headlights off before the
ignition, they will turn off in the normal
manner.
NOTE:
• The lights must be turned off within
45 seconds of placing the ignition in the
OFF position to activate this feature.
• The headlight delay time is programmable
using the Uconnect System, refer to
"Uconnect Settings" in "Multimedia" in
the Owner's Manual
www.mopar.eu/owner for further details.
on
35