Daytime Running Lights (Drls); If Equipped; High Beams; Automatic High Beam Headlamp Control - Jeep RENEGADE 2021 Owner's Manual

40 GETTING TO KNOW YOUR VEHICLE
Turning on the headlights will illuminate the
instrument cluster and the controls located on
the instrument panel.
NOTE:
On vehicles sold in Canada, both the rear posi-
tion lights and Daytime Running Lights (DRLs)
will turn on when the headlight switch is rotated
to the "Off" ("O") position.
D R L
AYTIME UNNING IGHTS
I E
F QUIPPED
The Daytime Running Lights (DRLs), if enabled
through Uconnect Settings, will turn on when
the instrument cluster is on and remain on
unless the headlights are turned on or the
instrument cluster is switched off.
NOTE:
For vehicles sold in Canada, the Daytime

Running Lights will automatically deactivate
when the front fog lights are turned on.
On some vehicles, the Daytime Running

Lights may deactivate, or reduce intensity, on
one side of the vehicle (when a turn signal is
activated on that side), or on both sides of
the vehicle (when the hazard warning lights
are activated).
H B
IGH EAMS
To activate the high beam headlights, push the
multifunction lever forward (toward the front of
the vehicle), and an indicator will illuminate in
the instrument cluster display.
To deactivate the high beam headlights, pull the
multifunction lever rearward (toward the rear of
the vehicle).
(DRL ) —
S
High Beam And Turn Signal Controls
NOTE:
The headlights must be on for the high beams
to activate.
A H B H
UTOMATIC IGH EAM
C — I E
ONTROL F QUIPPED
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automatically controlling the high
beams through the use of a camera mounted
on the inside rearview mirror. This camera
detects vehicle specific light and automatically
switches from high beams to low beams until
the approaching vehicle is out of view.
NOTE:
The multifunction lever must be in the high

beam position in order to activate the Auto-
matic High Beams.
The Automatic High Beam Headlamp Control

can be turned on or off using the Uconnect
system Ú page 159.
Broken, muddy, or obstructed headlights

and taillights of vehicles in the field of view
will cause headlights to remain on longer
(closer to the vehicle). Also, dirt, film, and
other obstructions on the windshield or
camera lens will cause the system to func-
tion improperly.
EADLAMP