Daytime Running Lights (Drl) - If Equipped; High Beams; Flash-To-Pass; Automatic Headlights - If Equipped - Jeep Renegade 2019 User Manual

Headlight Switch
Turning on the headlights will illuminate the
instrument cluster and the controls located
on the instrument panel.
Daytime Running Lights (DRL) — If
Equipped
The Daytime Running Lights (DRLs) will turn
on when the engine is started and remain on
unless the headlights are turned on or the
engine is shut off.
28
The DRLs will be disabled during turn signal
operation and resume operation when the
turn signal operation has ended.

High Beams

To turn on the high beam headlights, push
the turn signal lever forward (toward the front
of the vehicle) and an indicator will illumi-
nate in the cluster. To turn off the high
beams, pull the turn signal lever rearward
(toward the rear of the vehicle).
High Beam And Turn Signal Controls
NOTE:
The headlights must be on for the high beams
to activate.

Flash-To-Pass

You can signal another vehicle with your
headlights by lightly pulling the multifunc-
tion lever toward you. This will cause the
headlights to turn on at high beam and re-
main on until the lever is released.
Automatic Headlights — If Equipped
This system automatically turns the head-
lights on or off according to ambient light
levels. To turn the system on, rotate the
headlight switch clockwise to the last detent
(AUTO position) for automatic headlight op-
eration. When the system is on, the headlight
time delay feature is also on. This means the
headlights will stay on for up to 90 seconds
after you place the ignition into the OFF
position. To turn the automatic system off,
move the headlight switch out of the AUTO
position.
Refer to "Headlight Delay" in this section for
more information.
NOTE:
The ignition must be in the RUN or START
position before the headlights will come on in
the automatic mode.