Heated/Ventilated Seats - Jeep CHEROKEE 2017 User Manual

Memory Seat Buttons
To set a memory position:
1. Place the vehicle's ignition in the ON
mode.
2. Adjust all memory profile settings.
3. Push and release the S (set) button.
4. Push and release the 1 or 2 button within
five seconds.
26
NOTE:
Before programming your key fob you must
select the "Linking And Unlinking The Re-
mote Keyless Entry Key Fob To Memory"
feature through the Uconnect system. Refer
to "Uconnect Settings" in "Multimedia" in
the Owner's Manual on www.mopar.eu/owner
for further details.
To program a key fob to the memory position:
1. Cycle the vehicle's ignition to the OFF
position.
2. Select the desired memory profile 1 or 2.
3. Push and release the S (set) button on the
memory switch, then within five seconds
push and release the 1 or 2 button
accordingly.
4. Push and release the lock button on the
key fob within 10 seconds.
To recall the saved positions, push 1 or 2 on
the memory switch or push unlock on the
programmed key fob.
Easy Entry/Exit Feature
The memory seat has an Easy Entry/Exit fea-
ture. This feature provides automatic driver
seat positioning to enhance driver mobility
when entering and exiting the vehicle.
NOTE:
The Easy Entry/Exit feature is not enabled
when the vehicle is delivered from the fac-
tory. To enable (or later disable) this feature
you must select "Easy Exit Seats" in "Engine
Off Options" through the programmable fea-
tures in the Uconnect system.For further de-
tails refer to "Uconnect Settings" in "Multi-
media" in the Owner's
www.mopar.eu/owner for further details.

Heated/Ventilated Seats

Front Heated Seats
If your vehicle is equipped with front heated
seats, the control buttons are located within
the Uconnect system. You can gain access to
the control buttons through the climate
screen or the controls screen.
• Press the heated seat button
turn the HI setting ON.
Manual on
once to