Table of Contents
Advertisement
The DRLs will be disabled during turn signal
operation and resume operation when the
turn signal operation has ended.
High Beams
To turn on the high beam headlights, push
the turn signal lever forward (toward the front
of the vehicle) and an indicator will illumi-
nate in the cluster. To turn off the high
beams, pull the turn signal lever rearward
(toward the rear of the vehicle).
High Beam And Turn Signal Controls
NOTE:
The headlights must be on for the high beams
to activate.
Flash-To-Pass
You can signal another vehicle with your
headlights by lightly pulling the multifunc-
tion lever toward you. This will cause the
headlights to turn on at high beam and re-
main on until the lever is released.
Automatic Headlights — If Equipped
This system automatically turns the head-
lights on or off according to ambient light
levels. To turn the system on, rotate the
headlight switch clockwise to the last detent
(AUTO position) for automatic headlight op-
eration. When the system is on, the headlight
time delay feature is also on. This means the
headlights will stay on for up to 90 seconds
after you place the ignition into the OFF
position. To turn the automatic system off,
move the headlight switch out of the AUTO
position.
Refer to "Headlight Delay" in this section for
more information.
NOTE:
The ignition must be in the RUN or START
position before the headlights will come on in
the automatic mode.
Light Sensor
The light sensor is equipped with an infrared
LED, located on the windshield. It detects
changes in light intensity outside the vehicle,
based on the sensitivity of light set by using
the menu on the display or on the Uconnect
system.
The higher the sensitivity, the lesser the
amount of external light required for control-
ling the lighting.
Automatic High Beam Headlamp Control
— If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control
through the use of a digital camera mounted
on the inside rearview mirror. This camera
detects vehicle specific light and automati-
cally switches from high beams to low beams
until the approaching vehicle is out of view.
NOTE:
• The multifunction lever must be in the high
beam position in order to activate the Au-
tomatic High Beams.
29
Advertisement
Chapters
Table of Contents
