BIO RAD PowerPac HV Series Instruction Manual page 24

PowerPac HV – Instruction Manual
Step Procedure
5. Method steps
New method
METHOD: NAME
* S1 (EMPTY)
METHODS
METHOD: NAME
Existing method
* S1 100V 00:30 HRS
S2 (EMPTY)
METHODS DELETE
6. Set the constant
parameter for the
current step
7. Enter limits for the
non-constant
parameters for the
current step
S1/1 EDIT LIMITS
TIME: UNTIMED
CONSTV LIMITA
16
Description
Press EDIT to enter the edit loop.
• Press the up and down arrows to select an
existing step or select the (EMPTY) step to add a
new step
• Press EDIT again to enter the edit loop for the
selected step
SAVE
Use the soft keys to select the constant parameter
and the keypad to enter its value. Note that the
non-constant values are listed on the right side of
the screen and the time mode at the bottom.
The S#/# indicates which step is being modified. In
this case, S1/1 means editing step 1 of 1.
CONSTV:
CONSTA:
CONSTW: Operates with constant power.
Press EDIT to continue.
Use the soft keys to select a parameter and the
alphanumerical keypad to enter its value.
The soft keys CONST_ or LIMIT_ change according
to the constant parameter selected in the EDIT
CONSTANT screen.
500 mA Note: The constant parameter value can be
400 W
changed at this point. Press its soft key and enter a
new value.
LIMITW
LIMITV
(CONSTV): value.
LIMITA
(CONSTA): value.
LIMITW
(CONSTW): value.
Press EDIT to continue.
Operates with constant voltage.
Operates with constant current.
Change the voltage limit (or constant)
Change the current limit (or constant)
Change the power limit (or constant)