Removing The Lower Drive Plate - Digital Equipment VAXstation 3100 Series Upgrade Manual

Removing the Ethernet ROM
Figure 3–6 Removing the Lower Drive Plate
Captive
Screws (2)
Lower Drive Plate
3–10 Removing Options from a Model 40 and 48 Workstation
Depending on the system configuration, the Model 40 or
48 system can have two types of coprocessor modules: the
graphics coprocessor module or the scanline coprocessor
module. These two modules are similar except for a
couple features. To remove the scanline coprocessor, you
must remove three screws from the mounting brackets,
then release the tabs from the post locks. The graphics
coprocessor module has only four post locks with tabs
holding it to the system board.
Captive
Screws (2)
Slide Mount
Screws (3)
Slide Mount Openings (3)
Note
MLO-006510