Digital Equipment VAXstation 3100 Series Upgrade Manual page 49

6. Remove the SCSI terminator access door and the SCSI
7. Slide the drive plate towards the front of the system and lift
Remove the supported RZ2x disk drives from the drive plate.
Remove RZ2x
Two of these drives may be installed into the VAXstation 4000
Disk Drives
system unit.
To remove the RZ2x disk drives from the drive plate, do the
following and refer to Figure 4–3:
1. Push down on the drive plate lever.
2. Push down on the RZ2x disk drive and slide it over the drive
3. Lift the disk drive up and off the drive plate. Place the disk
When you remove the lower drive plate from the system
unit, do not make contact with the circuit boards under
the drive plate, such as the system board and the
memory boards. Contact between the drive plate and the
circuit boards could cause the circuit boards irreparable
damage.
terminator from the back of the system unit (if present).
it out of the system unit.
plate lever.
drives aside.
Removing Options from a Model 76 Workstation 4–5
Removing Fixed Disk Drives
Caution: