Remove The Upper Drive Plate - Digital Equipment VAXstation 3100 Series Upgrade Manual

Removing Fixed Disk Drives
To remove the upper drive plate, do the following and refer to
Remove the
Figure 3–2 and Figure 3–3:
Upper Drive
Plate
1. Disconnect the SCSI signal cables from all the RZ2x disk
2. Disconnect the internal power cables from all the RZ2x disk
3. Disconnect the internal power cable from the power supply.
4. Disconnect the SCSI signal cable from the SCSI/ST506 mass
5. Lift the RRD40 adapter module from the four plastic
6. Loosen the five captive screws shown in Figure 3–3.
7. Slide the drive plate with attached disk drives forward and
3–4 Removing Options from a Model 40 and 48 Workstation
drives.
drives.
storage module.
standoffs. Let the module extend over the back of the system
unit.
lift it off the unit.