Forming The Upper Cable In A Loop At The Desqa Module - Digital Equipment VAX 4000 Model 200 Installation Manual

4. Connect the T-connector to the ThinWire connector on the module as
shown in Figure 26. Push in and turn the T-connector clockwise until
it locks in place.
5. Use the cable clamp shipped with the module to form the upper cable
in a loop approximately 10 centimeters (4 inches) in diameter as shown
in Figure 27.
Figure 27: Forming the Upper Cable in a Loop at the DESQA Module
6. Connect the ThinWire cable to one of the following devices.
• A ThinWire Ethernet Multiport Repeater (DEMPR), which can be
connected to a baseband Ethernet cable and which connects up to
eight ThinWire segments in a local area network
• A ThinWire Ethernet Singleport Repeater (DESPR), which can be
connected to a baseband Ethernet cable and which connects to one
ThinWire segment
• A ThinWire Ethernet adapter in another system or workstation
NOTE: Contact your network manager or Digital service representative if
you have questions about network configurations.
Recommended
Diameter Is
10 Centimeters (4 Inches)
Cable Clamp
MLO-004020
VAX 4000 Model 200 (BA430) Installation 43