Table of Contents
Advertisement
REMOTE COMMISSIONING (DECENTRAL INITIAL OPERATION)
ENERGY / HOUR
This enables users to read the current values (actual value) for a specific output (output) for the on period and the
total consumption in KWh. "Last change" shows when the values were last changed manually. If Yes is selected for "Set
energy" and "Set hours", users can reset both the hours and the consumption, and set any value entered under "Value".
If there is no measurement chip (energy measurement) in the receiver, the following information appears on the display:
INPUTS
The submenu enables users to modify and view the Easyclick Plus function and mode of an external input, e.g. with the
AST devices (type D 45x ....or similar, and adapter D 45x1 FU-EBIM, etc.)
If no AST devices are available, the following display appears:
PEHA_M_450FU_HS128 (Rev02-26.07.17)
= Back to the Selection menu
= OK and transfer changes to the receivers
= Back to the Selection menu
= Back to the Selection menu
= OK and transfer changes to the receivers
D - 25
Advertisement
Table of Contents
