REMOTE MANAGEMENT
All the modules with this password will then be enabled and will register. The following display appears during the search:
The devices found or their ID addresses are shown in the display:
STANDARD COMMANDS
In accordance with the EnOcean definition, there are corresponding standard commands that also work across the
company. Below is a list and explanations of the commands:
• Action: Carries out a visual action to identify the device, e.g. switching the channel On/Off.
The following applies to PEHA switch and dimmer receivers: switched on for 5 seconds if previously off, or turned off
if previously switched on. PEHA roller shutter receivers activate shutters up or down for 5 seconds.
• Start learn: Places the receiver in learning mode. Corresponds to pressing the "LRN" button on the receiver.
• Next channel: Changes the receiver channel (e.g. with a 2-channel receiver), if it is in learning mode.
• Stop learn: Ends learning mode.
• Set code: Enables users to set a new key word in the receiver. If the code is no longer set to "00000000", the device
can be accessed at any time.
D - 22
= End of Remote Management, session closed
= indicates the maximum remaining time in which the Remote Management functions
can be carried out before the receiver ends the session
= Display all the channels in the handheld transmitter
= Display all the channels in the handheld transmitter
= Back to the Selection menu
PEHA_M_450FU_HS128 (Rev02-26.07.17)