Table of Contents
Advertisement
SERVICE TOOL
Use the cursor button
ID
Type Data type
The following data types are available:
RPS (e.g. wall switch)
1BS (e.g. window contact)
4BS (e.g. light sensors, handheld transmitters, movement detector....)
Press the cursor button
ID
LEV Level (signal strength in dBm)
Sub Data content of a telegram: When sending a telegram, three sub-telegrams are normally
Qual Quality in %: Values under 30% are borderline. Anything above this is acceptable.
Radio signal: O = transmitter (original telegram) ; R1 = 1-level repeater ; R2 = 2-level repeater
REPEATER
The handheld transmitter can be used as a 1-level or 2-level repeater (radio amplifier) for test purposes. Use the cursor
buttons
,
to switch between 1-level, 2-level and OFF. The repeater function is switched off when the EnOcean
Service is completed.
Settings
Login
Language
Histogram
EnOcean service
Remote management
Factory settings
2.00
l
PEHA_M_450FU_HS128 (Rev02-26.07.17)
to display the following details on the telegram sent:
ID address of transmitter Data Data content
ST.
again to display further details on the telegram sent:
ID address of the transmitter
Highest level: approx. -45 dBm
Lowest level: -85 dBm (1 bar)
generated. If only one sub-telegram is displayed, it may have been lost.
If possible the value should be over 50%.
Repeater
l
EnOcean monitor
ID_
O
R1
R2
~
Monitor
Press button
Deactivate repeater = Off
Back (to Settings): ...........................
Select repeater: ..............................
Select EnOcean service: ................. ,
Telegram status byte is only displayed by the above data types
Repeater
1 Level
Repeater
1-level, 2-level
,
D - 19
Advertisement
Table of Contents
