FireClass FC-P-S Service And Maintenance Manual page 8

2.3 Using the Menus
FireClass
Wed, 17-Aug-11
16:37
High Street Office
General
Flt P 011
Back
Fig. 1: Main Menu
Select the menu options by their number (press the
appropriate number key). Each option leads to a further
screen, which may present further options.
Details of the menu screens are provided in section 3
"Menu Details" on page 11.
In using the menus you always use combinations of the
same basic methods – to navigate between the various
settings in a screen for example. To avoid repetition this
guide does not provide full step by step details for each
screen. Instead, the illustration below serves as an example
of how you use the basic methods. The illustration is based
on discovering the status of a point.
How to discover the status of a point
1 Enter your passcode to display the Main Menu (this is
not strictly necessary when viewing status, and is only
included for the purposes of the illustration):
FireClass
Wed, 17-Aug-11
16:37
High Street Office
General
Flt P 011
Back
Fig. 2: Main Menu
2 Press the 2 key to display the View Status menu:
8
Main Menu
1 - Accept Events
2 - View Status
3 - Disablements
4 - Time / Date
5 - Event Log
6 - View/Print Data
7 - Service
8 - Configuration
9 - Test Buzzer,
LEDs & Display
Alarm Count: 0021
Main Menu
1 - Accept Events
2 - View Status
3 - Disablements
4 - Time / Date
5 - Event Log
6 - View/Print Data
7 - Service
8 - Configuration
9 - Test Buzzer,
LEDs & Display
Alarm Count: 0021
FireClass Fire detection system FireClass Panels
FireClass
Wed, 17-Aug-11
10:37
High Street Office
General
Flt P 011
Back
Fig. 3: View Status
3 Press the 1 key to display the next menu:
FireClass
Wed, 17-Aug-11
10:37
High Street Office
General
Flt P 011
Back
Fig. 4: View Status Point Selected
4 Press the 1 key to display the next screen:
FireClass
Thu, 18-Aug-11
11:07
High Street Office
General
Flt P 011
Back >>
Fig. 5: View Status Loop Highlighted
5 In this scenario, the loop setting (A) does not need
changing.
For a 2 or 4 loop configured panel, to change the loop,
highlight the loop setting and press + key to increment
it to the next loop or press - key to move to the previous
loop.
You press the >> key (F2) to move the highlight to the
point field:
Service and Maintenance Doc. version 1
View Status
1 - Point
2 - Point I/P only
3 - Point O/P only
4 - Zone
5 - Zone Maps
6 - Network Status
7 - Commis. O/View
View Status
Point
1 - Loop Point
2 - RBus Point
3 - Local I/O Point
View Status
Point
Panel
01
Loop Point
001
A
- + Enter