Advertisement
6. Attach a Dip Arm (5) to the right Upright (3) and
the Upright Base (2) with two M8 x 77mm Bolts
(28), a Support Plate (13), and two M8 Locknuts
(22); do not tighten the Locknuts yet.
Repeat this step with the other Dip Arm (5)
and the left Upright (not shown).
7. Attach the Top Crossbar (7) to one of the Dip
Arms (5) with two M8 x 75mm Bolts (17), two M8
Washers (23), and two M8 Locknuts (22); do not
tighten the Locknuts yet.
Attach the Top Crossbar (7) to the other Dip
Arm (5) in the same way.
8. Attach the Pull-up Bar (9) to the Uprights (3) with
two M10 x 50mm Screws (19) and two M10
Washers (26). Make sure that the indented
holes in the Pull-up Bar are on the side
shown. Then, press the two Rubber Caps (12)
into the ends of the Uprights.
See steps 2–7. Tighten all the M8 Locknuts
(22).
6
5
7
5
8
Indents
3
9
3
22
13
22
2
5
7
22
23
23
5
17
19
12
26
9
26
3
28
12
19
Advertisement
