Advertisement
4. Attach a Support (4) to one of the Stabilizers (1)
with the two indicated M8 x 68mm Carriage Bolts
(20) and two M8 Locknuts (22); do not tighten
the Locknuts yet.
Next, attach the Support (4) to the Upright Base
(2) with two M8 x 75mm Bolts (17), two M8
Washers (23), and two M8 Locknuts (22); do not
tighten the Locknuts yet.
Attach the other Support (4) to the other
Stabilizer (not shown) and the other Upright
Base (2) in the same way.
5. Orient one of the Uprights (3) as shown, and
attach it to the left Upright Base (2) with two M8 x
68mm Bolts (24), two M8 Washers (23), and two
M8 Locknuts (22). Note: The Bolts must be
attached to the lowest set of holes in the
Upright and the Upright Base. Make sure that
the bolt heads are in the hexagonal holes in
the Upright Base. Do not tighten the Locknuts
yet.
Attach the other Upright (3) to the other
Upright Base (2) in the same way.
4
22
4
22
22
22
5
3
2
8
2
2
23
17
23
1
4
20
3
24
23
2
22
23
Advertisement
