Huawei VP9660 Quick Start Manual page 32

HUAWEI VP9660
Quick Start Guide
Step 2 Two PRI cables form a pair, connect the SMB connectors (female) at one end of the PRI
cables to the Tx port and Rx port in the front panel of the PRI cable box, and then connect the
SMB connectors (female) at other end of the PRI cables to the XR port and XT port of the
switch.
XT refers to the sending direction. XR refers to the receiving direction.
For example, connect the SMB connectors (female) at one end of the PRI cables to the Tx0
port and Rx0 port in the front panel of the PRI cable box, and then connect the SMB
connectors (female) at other end of the PRI cables to the XR0 port and XT0 port of the switch,
as shown in
Figure 2-21 Cable connection of the PRI cable box and the switch
Illustrations listed in
If you use the PRI cable box (120-ohm balanced), connect the RJ45 connector of the network cable to
the RJ45 port as shown in
switch port to which the cable is to be connected.
Step 3 Repeat
----End
Issue 04 (2013-12-30)
Figure 2-21.
Figure 2-19,
Figure
Step 2 to connect other PRI cables to the PRI cable box and the switch.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 2-20 and Figure 2-21
2-17. Prepare the other connector of the network cable based on the
2 Installing the VP9660
are for your reference only.
28