Using The Pc Running A Third Party Software For Programming; Main Programming Menu; Alter Dimensional Weight [Dim] Factors - Global Sensor Systems ExpressCube 265R User Manual

7.4.

Using the PC running a Third Party Software for Programming

The ExpressCube™ countertop unit has an API interface which allows third party software to
operate, acquire data and utilize the user program feature set. Refer to the manufacturer's
instruction on the use of programming features with the third party software.
***IMPORTANT*** Third party software will have access to all data from the
™
ExpressCube countertop data including measurements, units, dimensional weight,
dimensioning factor and handheld scanner codes; however, the software manufacturer may
use the ExpressCube
only. If the third party software determines dimensional weight, only accessing the third
party software can change dimensional weight factors.
7.5.

Main Programming Menu

7.5.1. Alter Dimensional Weight [DIM] Factors

Selecting this menu allows the user to review or change any of the four dimensional factors
used by the ExpressCube™ countertop computer to calculate dimensional weight.
Sub-menu:
1. (Dim Factor) [Units]
2. (Dim Factor) [Units]
3. (Dim Factor) [Units]
4. (Dim Factor) [Units]
5. BACK
Select the dim (dimensional weight) factor that you wish to change and verify the correct
units before entering the new value.
The dimensional weight factors can only have four digits with the last digit
representing units or tenths. (e.g. 000.0 to 9999) Any entry of four or less digits will be
assumed whole numbers unless a decimal is used. The maximum dim factor setting is
3
276 in /lb
The Dim Factors are displayed in the units that they were originally input but the
™
ExpressCube
match the units that are used.
The dimensional factor displayed and output from the unit will always match the units
that the measurements were taken.
™
countertop to measure, weigh and collect handheld scanner codes
countertop computer will convert the dimensional weight factors to
17