How To Use Flashscan Poll - Notifier AFC-600 Programming Manual

How to Use FlashScan Poll

+RZWR8VH)ODVK6FDQ3ROO
&
3URJUDP &KDQJH
SDVVZRUG
&
)
WR H[LW
AFC-600 Programming PN 51032:A 3/8/99
Technical Manuals Online! - http://www.tech-man.com
)ODVK6FDQ3ROO2SWLRQV
From the Program Change Selection screen (Figure 7 on page 14), press the 4 key to
access the FlashScan Poll selection screen (Figure 44).
)/$6+6&$1
)LJXUH  )ODVK6FDQ 3ROO 6HOHFWLRQ 6FUHHQ
This menu allows the selection of CLIP (Classic Loop Interface Protocol) or FlashScan
detectors and modules for each loop. Once this screen is accessed, the cursor will be
positioned underneath the Loop #1 Detector selection, blinking the currently selected
protocol type. The default selections are shown in Figure 44. This indicates that both
Loop #1 and Loop #2 detectors and modules are selected to use CLIP devices. If
FlashScan devices are to be employed, change the blinking cursor by pressing the Y key
or toggle it by using the
PREVIOUS
the detectors and modules of both loops, press the
will reset.
Observe the following protocol when using FlashScan devices:
• FlashScan devices can be programmed to run in either CLIP or FlashScan mode
• FlashScan devices cannot be mixed with CLIP devices on the same loop, unless the
entire loop is programmed for CLIP mode
• FlashScan programmed detectors cannot be used with CLIP modules on the same
loop
The following table lists the available FlashScan devices:
Type
ION
Photo
Photo/Thermal
Duct Detector
Laser Detector
Multi Detector
Thermal
Thermal R-O-R
Monitor Module
Micro Monitor Module (for pull
station replacement)
Mini Module
2-Wire Detector Monitor Module
Control Module - NAC
Control Module - Relay
/'(7 /02' /'(7 /02'
1 1 1
or key. After the selections have been made to
NEXT
ENTER
Notifier
FSI-751
FSP-751
FSP-751T
FSD-751
FSL-751
FSM-751
FST-751
FST-751R
FMM-1
FSM-1
FMM-101
FZM-1
FCM-1
FRM-1
7DEOH  )ODVK6FDQ 'HYLFHV
 3URJUDP &KDQJH
1
key, at which time the panel
37