Create A New Program For The Control Panel; How To Add A Device To The Program; How To Remove A Device From The Program; How To Change Autoprogram Defaults For System Functions - Notifier AFC-600 Programming Manual

 3URJUDP &KDQJH
3XUSRVH
&UHDWH D 1HZ 3URJUDP
IRU WKH &RQWURO 3DQHO
16
Technical Manuals Online! - http://www.tech-man.com
+RZWR$XWRSURJUDPWKH&RQWURO3DQHO  $872
The Autoprogram option identifies all addressable devices connected to the control
panel. Devices include addressable detectors and modules connected to SLC 1 and
SLC 2, Panel Circuits connected to J1 and J2, and NACs. You can use the Autoprogram
option to create a new program and add or remove devices. Table 6 contains a summary
of the Autoprogram functions, when to use the functions, and where to find information
on using the functions.
Autoprogram Function Control Panel Configuration
Create a new program A new control panel or a
for the control panel control panel with no existing
program in memory.
Add one or more A program exists in memory
SLC-connected and you want to add a detector
detectors and modules or module to the existing
to an existing program program—without modifying
information for existing
detectors and modules.
Remove one or more A program exists in memory
SLC-connected and you want to remove an
detectors and modules installed detector or module
from an existing from the existing program—
program without modifying information
for existing detectors and
modules.
View system defaults A program exists in memory
and you want to view system
settings assigned during
Autoprogram, such as custom
labels, passwords, and so on.
7DEOH  $XWRSURJUDP )XQFWLRQV
This section covers how to use the Autoprogram option to create a new program for the
control panel. The control panel will identify all addressable detectors and modules
connected to the SLC then display default program information for each installed
device.
To create a new program for the control panel, follow these steps:
1. Use the Clear option to clear program information from memory. For instructions
on clearing memory, refer to "How to Clear Memory (0=
2. From the Program Change screen, press the 1 key to start Autoprogram. The
control panel scans the system to identify all SLC devices and Panel Circuits and
displays the following screen:
$872352*5$0 3/($6( :$,7
)LJXUH  $XWRSURJUDP 3URPSW
AFC-600 Programming PN 51032:A 3/8/99
How to Use the Basic Program
Refer to...
"Create a New Program for the
Control Panel" on page 16
"How to Add a Device to the
Program" on page 18
"How to Remove a Device from
the Program" on page 19
"How to Change Autoprogram
Defaults for System Functions"
on page 20
)" on page 15.
CLR
Continued on the next page...