How To Use The Utility Program - Notifier AFC-600 Programming Manual

How to Use the Utility Program

+RZWR8VHWKH8WLOLW\3URJUDP
&
3URJUDP &KDQJH
SDVVZRUG
&
)
WR H[LW
AFC-600 Programming PN 51032:A 3/8/99
Technical Manuals Online! - http://www.tech-man.com
8WLOLW\3URJUDP2SWLRQV
From the Program Change Selection screen (Figure 7 on page 14), press the 3 key to
display the Utility Program screen (Figure 43).
'<132// 1 7%/5(0,1'  $/$6&52// <
/2&$/ &21752/ <
)LJXUH  8WLOLW\ 3URJUDP 6FUHHQ
Table 20 contains descriptions of the three options on the Utility Program screen.
Utility Option Description
Dynamic Poll This option determines the polling speed for the SLC, which you can
select as follows:
• Select Y if you want to optimize the SLC for a harsh noise
environment
• Select N to optimize the response speed of the SLC (default).
TBL Reminder This option provides trouble resound selections to meet the requirements
of NFPA 72, which you can select as follows:
• Select * if you don't want a trouble reminder
• Select 1 to sound a short trouble reminder tone every minute
• Select 2 to resound a trouble tone every 24 hours (default)
• Select 3 to display a detector while in the alarm verification mode and
no trouble reminder
• Select 4 for once a minute trouble reminder with alarm verification
display
• Select 5 for trouble reminder resound every 24 hours with alarm
verification display
Alarm Scroll This option allows you to select how alarms are displayed.
• Select Y if you want each alarm displayed for approximately two
seconds (default)
• Select N if you want only the first alarm and the alarm count displayed
Local Control This option allows you to disable local control of the
key,
STEP
local control as follows:
• Select N to disable local control
• Select Y to enable local control (default)
7DEOH  8WLOLW\ 3URJUDP 2SWLRQV
key and
ALARM SILENCE SYSTEM RESET
 3URJUDP &KDQJH
/
ACKNOWLEDGE
key. You can select
35