Advertisement
RZR INSTALLATION
1. Shift vehicle transmission into "PARK". Turn key to
"OFF" position and remove from vehicle.
2. Gain access.
a. Remove hood.
b. Remove windshield, as applicable.
c. Remove seat to gain battery access.
3. Disconnect black negative (-) cable from battery.
4. Loosely route 4–pin end of harness
hood compartment rearward through firewall
grommet into upper dash compartment.
5. Install switch module.
a. Remove two screws
dash panel, then carefully pull panel rearward,
disengaging seven retaining clips
If necessary for access, label and disconnect
other electrical harnesses from control panel.
b. Carefully cut one rectangular switch blank from
upper dash panel.
Any open location may be used.
c. Install switch module
then connect 4–pin end of harness
as shown.
w
from under-
A
securing front of upper
B
as shown.
NOTE
q
to upper dash panel,
w
to switch
Instr 9927256
d. If other electrical harnesses were disconnected
in step a., reconnect them now.
e. Reinstall upper dash panel using two retained
screws
6. Install harness.
a. Drill out one accessory plug (1/4 inch) on
forward side of firewall, then install fuseholder
C
using attached fir tree clip as shown.
Control drill depth to prevent damage to underlying
b. Connect ring terminals to terminal block.
• ORANGE harness wire: To post with existing
ORANGE wire (with or without white stripe)
(accessory switched 12V POS); post may be
identified as "ACC"
• BROWN harness wire: To post with existing
BLACK battery connection cable (12V NEG);
post may be identified as "GND"
c. Secure harness as required to prevent contact
with hot components, sharp edges, or moving
parts.
7. Reconnect black negative (-) cable to battery.
8. Restore access.
Rev 01 2016-07
Page 5 of 8
A
.
IMPORTANT
structure or components.
Advertisement
