Advertisement
iii. Using fingers, remove center storage box
C
by pressing top edge of box down,
disengaging box locking tabs from main
dash panel as shown. Tip box out of dash
and remove.
IMPORTANT
Use only enough force to disengage locking tabs.
Excessive force may damage box.
d. Remove seat or seat bottom cushion, as
applicable, to gain battery access.
3. Disconnect black negative (-) cable from battery.
4. FULL-SIZE RANGER and GENERAL:
Route 4–pin end of harness
compartment rearward through firewall grommet
into upper dash compartment.
Mid-Size Ranger has no firewall grommet; direct
access to dash control panel exists with hood open.
5. Install switch module.
• FULL-SIZE RANGER:
a. Detach existing control panel by removing
D
two screws
panel as shown. Retain screws.
w
from under-hood
NOTE
from lower edge of control
Instr 9927256
b. Carefully pull control panel away from main
dash panel. If necessary for access, label
and disconnect other electrical harnesses
from control panel switches.
c. Carefully cut or remove, as applicable, one
rectangular switch blank from control panel.
Any open location may be used.
d. Route 4–pin end of harness
control panel and connect to switch module
q
, then install switch to panel as shown.
e. If other electrical harnesses were
disconnected in step b., reconnect them now.
f. Reinstall control panel using two retained
screws
• MID-SIZE RANGER:
Follow preceding FULL-SIZE RANGER
installation Steps 5c. and d.
• GENERAL:
a. Using fingers, remove center console control
panel by disengaging four spring clips
shown.
Rev 01 2016-07
Page 3 of 8
NOTE
w
D
.
through
E
as
Advertisement
