Problems When Booting The Device - Siemens SIMATIC IPC677E Operating Instructions Manual

Problem
Although the BIOS setting is
OK, the time and data are still
wrong
USB device not responding.
B.2.2

Problems when booting the device

Problem
After changing the hard disk,
the system does not boot from
the RAID array
After changing the drive, "un-
used" is indicated for the rele-
vant SATA port
Computer does not boot or
"Boot device not found" is
displayed.
SIMATIC IPC677E
Operating Instructions, 04/2019, A5E45117996-AA
Cause
The backup battery is dead.
USB ports are deactivated in the
BIOS Setup
Operating system does not support
the USB port.
Cause
RAID array does not have highest
boot priority
System was booted without func-
tioning hard disk. The removable
tray might not be fully pushed in.
The boot medium is not approved
The boot device is not in first place
of the boot priority in the BIOS
setup
Remedy
Replace the backup battery.
Use a different USB port or activate the port.
Activate the "Legacy USB Support" setup pa-
•
rameter in the "Advanced > USB Configuration"
menu of the BIOS Setup.
For other devices, you need the USB device
•
drivers for the required operating system.
Remedy
BIOS setup, Boot menu:
Permit RAID system in the boot priority
•
Give RAID system top boot priority
•
Reboot the system with a functioning hard disk.
Allow the boot device in the boot priority in the "Boot"
menu of the BIOS Setup.
In the BIOS setup "Boot" menu, change the boot
priority of "Boot device".
Technical support
B.2 Troubleshooting
145