Problems When Booting The Device - Siemens SIMATIC IPC PX-32A Operating Instructions Manual

Problem
Wrong time and/or date on the
PC.
Time and date are still incor-
rect, even after correct setting
in the firmware/BIOS
USB device not responding.
B.2.2

Problems when booting the device

Problem
Computer does not boot or
"Boot device not found" is
displayed.
SIMATIC IPC PX-32A
Operating Instructions, 09/2023, A5E53092695-AA
Cause
The backup battery is dead.
USB ports are disabled in the firm-
ware/BIOS
Operating system does not support
the USB port.
Cause
The boot medium is not approved
The boot medium is not in first
place of the boot priority in the
firmware/BIOS
The boot data carrier is set up with
GPT and UEFI boot is deactivated in
the firmware/BIOS
Remedy
1. Call the firmware/BIOS configuration menu. To do
this, press the "<Esc>" button during the boot
process and then select "Setup Utility".
2. Set the date and time in the "Main" tab and save
the changes.
Replace the backup battery.
Use a different USB port or activate the port.
For other devices, you need the USB device drivers
for the required operating system.
Remedy
In the firmware/BIOS, set the boot priority under
"Boot > Boot device" to "Enabled".
Change the boot priority in the firmware/BIOS under
"Boot > EFI".
Enable UEFI mode in the firmware/BIOS.
Technical support
B.2 Troubleshooting
91