Pitch - Star Micronics NX-15 User Manual

—
46
Here line 30 turns on superscripts with (ESC) "S" O.It's turn-
ed off in line 50 with (ESC) "T". Then between printing text,
subscripts are turned on in line 70 with (ESC) "S" 1, and finally
off in line 90. Again, everything prints on one line because of the
semicolons.
CHANGING THE PRINT PITCH
In "printer talk," the number of characters that can be printed
in one inch is called the print pitch or character pitch. Normally,
your printer is set for 10 characters per inch, which is called pica
(and is the same as the pica pitch on most typewriters). This
works out to 136 characters per line.
You can also print 12 character per inch (elite ~itch). This
gives you 163 characters per line.
You can set these pitches by using the Mode key on the con-
trol panel manually, or by software as shown in the table below.
Table 4-5
Print pitch commands
Pitch
Characters/inch Control code
Pica
10 (ESC) "P"
Elite
12 (ESC) "M"
Try this program to see how these two pitches work. Be sure
to set the printer to draft mode.
10 ' Demoof pica and e
20 LPRINTCHR$ (27) ; "M";
30 LPRINT "This 1ine is
40 LPRINTCHR.$ (27 ) ; "P" ;
50 LPRINT "This 1ine is
ite p:
t.ches
ELITE pitch. "
PICA pitch (normal ) ."
When you run this program you should get this:
Th 1s 11
ne is.
EL 11""Ep ~ tr:h.
'"l"l'"i 1.s:. :1. 1 ,I""i P i '3 1':" [ (l[\ pi.
t (:::h
Line 20 turns on elite pitch with