Guitar Amp Classics - Steinberg UR22C Operation Manual

Guitar Amp Classics

Guitar Amp Classics are guitar amp simulations that make
extensive use of advanced Yamaha modeling technology.
Four amp types with different sonic characteristics are
provided.
The Guitar Amp Classics equipped with the device and
the Guitar Amp Classics of the VST Plug-in version have
the same parameters. When using the Guitar Amp
Classics on Cubase series programs, you can share the
settings between the built-in Guitar Amp Classics and the
Guitar Amp Classics of the VST Plug-in version as a
preset file. Also, when assigning the Guitar Amp Classics
of the VST Plug-in version to the effect slot on Cubase
series programs, select it from the [Distortion] category (in
the case of the default settings). Note that Guitar Amp
Classics equipped with the device cannot be used when
the sample rate is set to 176.4 kHz or 192 kHz.
Screenshot
How to Open the Window
From Dedicated Windows for Cubase Series
Select the "Guitar Amp Classics" from the "Effect Type",
then click "Effect Edit" in the section "Input Settings
Window" (page 14).
From dspMixFx UR-C
Select the "Guitar Amp Classics" from the "Effect Type",
then click "Effect Edit" in the section "Channel Area"
(page 9).
CLEAN
1 2 3
This amp type is optimized for clean tones, effectively
simulating the tight brilliance of transistor amplifiers. The
tonal character of this amp model provides an ideal
platform for recording with multi-effects. It also features
built-in chorus and vibrato effects.
1 VOLUME
Adjusts the amplifier's input level.
2 DISTORTION
Adjusts the depth of distortion produced.
3 TREBLE/MIDDLE/BASS
These three controls adjusts the amplifier's tonal response
in the high, middle, and low frequency ranges.
4 PRESENCE
Can be adjusted to emphasize the high frequencies and
overtones.
5 Cho/OFF/Vib
Turns the Chorus or Vibrato effect on or off. Set to [Cho] to
turn the Chorus effect on, or to [Vib] to turn the Vibrato
effect on.
6 SPEED/DEPTH
These controls adjust the speed and depth of the Vibrato
effect when it is on. The SPEED and DEPTH controls only
work with the Vibrato effect, and are disengaged when the
Cho/OFF/Vib control, above, is set to "Cho" or "OFF."
7 BLEND
Adjusts the balance between the direct and effect sound.
8 OUTPUT
Adjusts the final output level.
Software
5 6
4 7 8
UR22C Operation Manual 20