Steinberg UR22C Operation Manual page 14

6 Phase
Switches phase inversion on (lit) and off (unlit). Shows L, R
when stereo is selected.
Effect Settings area
This area is used to set parameters related to the UR22C
input/output port effects.
1
2
3
4
6
7
8
1 Pre/Post
Used to select the insertion point for the effect.
2 Effect Name
Displays the names of the applied effects.
3 Effect Bypass
Enables/bypasses the effect.
4 Effect Edit
Displays the Effect Edit window.
5 Effect Type
Selects the effect type.
Settings: No Effect, Morphing Ch Strip ([m] or [s]), GA Classics -
CLEAN, GA Classics - CRUNCH, GA Classics - LEAD,
GA Classics - DRIVE
The maximum number of Channel Strip and Guitar Amp Classics
iterations which can be used simultaneously is limited. Refer to
the "Limitations on the use of effects"
6 REV-X Send
Adjusts the signal level which is sent to REV-X.
Range: -∞ dB − +6.00 dB
7 REV-X Name
Displays the selected REV-X type.
8 REV-X Edit
Opens the "REV-X" (page 18) setup window.
9 REV-X Type
Selects the REV-X type.
Settings: Hall, Room, Plate
5
9
(page 33).
Outputs area
This area is used to set parameters related to hardware
outputs.
1
2
4
1 Mix Bus name
Displays the Mix Bus name of the hardware output. The
output bus of the track must be connected to this Mix bus.
2 Output meter
Displays meters for the hardware Mix Bus connected to
hardware outputs.
3 Meter Clip
Displays the input meter clip when clipping occurs. Click
this to stop this display.
4 Headphones
The UR22C can be set only to phones1.
Software
3
UR22C Operation Manual 14