Recording/Playback - Steinberg UR22C Operation Manual

Recording/Playback

This section explains simple recording operations for
using a microphone. Connect a microphone to [MIC/LINE
1] jack as shown in the connection examples
Turn the [+48V] switch on when using a phantom powered
condenser microphone.
The explanation uses Cubasis (DAW app) as an example.
• iOS app may not be supported in your area. Please check with
your Yamaha dealer.
• For the latest Cubasis information, see the Steinberg web site
below.
https://www.steinberg.net/
1.
Open Cubasis.
2.
Tap the [MEDIA] tab on the upper left of the
screen.
[Create New Project] is shown in the bottom of the
screen.
3.
Tap the [Create New Project].
4.
Enter a project name and tap [OK] in the
[New project] window.
5.
Tap [+ADD] on the left of the screen, then
tap [AUDIO] to add an Audio Track.
(page 27).
6.
Tap
show the track inspector.
7.
Tap
the input bus for the track by tapping a
number.
8.
Tap
9.
Adjust the input signal level of the
microphone with the [INPUT 1 GAIN] knob
on the device.
Setting optimum recording levels
Adjust the [INPUT GAIN] knobs so that the [PEAK]
indicator flashes briefly at the loudest input volume.
Using with an iOS Device
on the far left of your screen to
to show the details window and set
to turn monitoring on (lit).
UR22C Operation Manual 28