Steinberg UR22C Operation Manual page 9

Main Window
This window is for configuring the entire signal flow.
Channel Area (page 9)
DAW Area (page 10)
REV-X Area (page 10)
Master Area (page 11)
Channel Area
This is the area for configuring the input channel settings.
1
2
4
6
7
9
)
!
1 Channel Link
Turns on (lit) and off (unlit) the channel link function of two
adjacent channels. When this is on, two mono channels
will become one stereo channel.
2 Level Meter
Indicates the signal level.
3 +48V
Indicates the on/off status of the phantom power function
of the device.
4 High Pass Filter
Turns on (lit) and off (unlit) the high pass filter. To select
the cutoff frequency of the high pass filter, use the "Setup
Window"
MIX Area (page 11)
5 Phase
Turns on (lit) and off (unlit) the phase inversion of the
signal.
6 FX REC
Turn the FX REC (effect recording) on and off.
Settings
On (lit)
Off (unlit)
7 Effect On/Off
Turns the Effect on (lit) and off (unlit).
8 Effect Edit
Opens (lit) and closes (unlit) the selected effect setup
window.
9 Effect Type
Selects the effect type.
Settings: NoEffect, Ch.Strip, Clean, Crunch, Lead, Drive
3
The maximum number of Channel Strip and Guitar Amp Classics
iterations which can be used simultaneously is limited. Refer to
5
the "Limitations on the use of effects"
) REV-X Send
8
Adjusts the signal level which is sent to REV-X.
Range: -∞ dB − +6.00 dB
! REV-X Send Value
Displays and adjusts the REV-X send value. Enable
editing of the value by double clicking the number.
(page 12) in the section "dspMixFx UR-C."
Description
Applies an effect to both the monitor
signal (sent to the device) and the
recording signal (sent to the DAW
software).
Applies an effect to only the monitor
signal (sent to the device).
(page
UR22C Operation Manual
Software
33).
9