Recording/Playback - Steinberg UR22C Operation Manual

Recording/Playback

This section explains simple recording operations for
using a microphone. Connect a microphone to [MIC/LINE
1] jack as shown in the connection examples
Turn the [+48V] switch on when using a phantom powered
condenser microphone.
Cubase Series Programs
1.
Launch the Cubase series DAW and display
the [steinberg hub] window.
2.
Select the template [Empty] in [Recording]
on the [steinberg hub] window, then click
[Create].
3.
Turn on Direct Monitoring as follows.
[Studio]  [Studio Setup]  [Yamaha Steinberg
USB ASIO] (Windows) or [Steinberg UR22C] (Mac)
 enter checkmark to [Direct Monitoring]  [OK]
4.
Return to the project window and click
[Project]  [Add Track]  [Audio] to display
[Add Track].
5.
Select the [Audio Inputs] and
[Configuration] to [Mono] and [Count] to [1],
and then click [Add track] to create one new
audio track.
6.
Confirm that the [Record Enable] and
[Monitor] indicators are turned on (lit) for the
added audio track.
7.
While singing into the microphone, adjust
the input signal level of the microphone with
the [INPUT 1 GAIN] knob on the device.
Setting optimum recording levels
Adjust the [INPUT GAIN] knobs so that the [PEAK]
indicator flashes briefly at the loudest input volume.
8.
While singing into the microphone, adjust
the output signal level of the headphones
with the [PHONES] knob on the device.
(page 23).
9.
Click
10.
After finishing the recording, click
stop it.
11.
Turn [Monitor] off (unlit) for the just
recorded audio track.
12.
Click the Ruler to move the project cursor to
the desired point for starting playback.
13.
Click
When listening to the sound over monitor speakers,
adjust the output signal level by the [OUTPUT] knob
on the device.
The recording and playback operations are now
complete.
For more detailed instructions on using Cubase series
programs, refer to the Cubase operation manual.
Using with a Computer
to start the recording.
to check the recorded sound.
UR22C Operation Manual
to
25