Steinberg UR22C Operation Manual page 11

MASTER Area
This is the area for configuring the master channel
settings.
1
2
1 Level Meter
Indicates the signal level.
2 Loop Back
Turns the Loopback function on (lit) and off (unlit).
What is Loopback?
Loopback is a convenient function for broadcasting
over the Internet. It mixes the input audio signals (such
as microphone and guitar) with the audio signals
playing back in the software in the computer into two
channels in the UR22C, and sends them back to the
computer. Refer to the section "Signal Flow"
If the Loopback function is on while you are monitoring
input signals from the UR22C via DAW software, it will
cause loud noise. This is because an infinite loop of the
audio signal is generated between the UR22C and the
DAW software. When using the loopback function, turn
off the monitor functions on your DAW software.
UR22C
MIX Area
This is the area for selecting the MIX you want to
configure. The UR22C can be set only to MIX1.
(page 34).
Deliver
BGM
Meter Window
This window is for showing the meter at the top of the Main
window.
1
1 Level Meter
Indicates the signal level. Peak hold is normally set to on.
Display color Description
Green Up to -18dB
Yellow Up to 0dB
Red CLIP
Software
UR22C Operation Manual 11