Signal Flows - Steinberg UR22C Operation Manual

Signal Flows

The following chart indicates the signal flow in the device.
• The controllers on the device, such as the [INPUT GAIN] knobs, [OUTPUT] knob are not included in this chart.
• To configure each parameter, use the "dspMixFx UR-C"
• Please note that you cannot use the built-in Guitar Amp Classics when the sample rate is set to 176.4 kHz or 192 kHz.
From From
[MIC/LINE 1] [MIC/LINE 2]
*1
Insert FX
Insert FX
SLOT1
SLOT1
SLOT2
SLOT2
MIX 1
REV-X REV-X
Send Send
Level Level
REV-X
*1 The following chart indicates an effect insertion location.
FX REC (ON)
From input on the device
Insert FX
SLOT1
SLOT2
To DAW input
To output on the device
• Set FX REC ON when recording the DSP effect processed signal with the DAW.
• Set FX REC OFF when recording a signal without DSP effect processing with the DAW.
(page 8) or "Dedicated Windows for Cubase Series"
From To
[MIDI IN] [MIDI OUT]
LOOPBACK OFF/ON
REV-X
Return
Level
FX REC (OFF)
From input on the device
To DAW input
Insert FX
SLOT1
SLOT2
To output on the device
Appendix
(page 13).
To DAW input
From DAW output
To [PHONES]
To [MAIN OUTPUT]
UR22C Operation Manual 34