Guitar Amp Classics - Steinberg UR44 Operation Manual

LPF
Adjusts the cutoff frequency of the low pass filter.
Range: 1.0 kHz – 20.0 kHz
Hi Ratio
Adjusts the duration of reverberation in the high
frequency range by using a ratio relative to the Reverb
Time. When you set this parameter to 1, the actual
specified Reverb Time is fully applied to the sound.
The lower the value, the shorter the duration of
reverberation in the high frequency range.
Range: 0.1 – 1.0
Low Ratio
Adjusts the duration of reverberation in the low
frequency range by using a ratio relative to the Reverb
Time. When you set this parameter to 1, the actual
specified Reverb Time is fully applied to the sound.
The lower the value, the shorter the duration of
reverberation in the low frequency range.
Range: 0.1 – 1.4
Low Freq
Adjusts the frequency of the Low Ratio.
Range: 22.0 Hz – 18.0 kHz
OPEN/CLOSE
Opens and closes the window for adjusting the reverb
settings.
Graph
Indicates the characteristics of reverberation. The
vertical axis indicates the signal level, the horizontal
axis indicates the time, and the Z-axis indicates the
frequency. You can adjust the characteristics of
reverberation by dragging the handles in the graph.
Time Axis Setting
Select the display range of the time (horizontal axis) on
the graph.
Display range: 500 msec – 50 sec
Zoom Out
Zooms out the display range of the time (horizontal
axis) on the graph.
Zoom In
Zooms in the display range of the time (horizontal axis)
on the graph.
HINT
• You can reset some parameters to the default value
by holding the [Ctrl]/[command] key while you click
on the knobs, sliders, and faders.
• You can adjust the parameters more finely by holding
the [SHIFT] key while you drag on the knobs, sliders,
and faders.

Guitar Amp Classics

Overview
Guitar Amp Classics are guitar amp effects that
make extensive use of advanced Yamaha modeling
technology. Four amp types with different sonic
characteristics are provided.
Please note that you cannot use the Guitar Amp
Classics when the sample rate is set to 176.4 kHz or
192 kHz. The maximum number of Channel Strip
and Guitar Amp Classics iterations which can be
used simultaneously has restrictions. Refer to the
"Limitations on the use of effects"
How to Open the Window
From Dedicated Windows for Cubase Series
Select the "Guitar Amp Classics" from the "Effect
Type", then click "Channel Strip Edit" in the section
"Input Settings Window" (page
From the dspMixFx UR44
Select the "Guitar Amp Classics" from the "Effect
Type", then click "Channel Strip Edit" in the section
"Channel Area" (page 11).
Controls and Functions
CLEAN
This amp type is optimized for clean tones, effectively
simulating the tight brilliance of transistor amplifiers.
The tonal character of this amp model provides an
ideal platform for recording with multi-effects. It also
features built-in chorus and vibrato effects.
VOLUME
Adjusts the amplifier's input level.
DISTORTION
Adjusts the depth of distortion produced.
TREBLE/MIDDLE/BASS
These three controls adjusts the amplifier's tonal
response in the high, middle, and low frequency ranges.
PRESENCE
Can be adjusted to emphasize the high frequencies
and overtones.
Software
(page 34).
15).
UR44 Operation Manual 21