Table of Contents
Advertisement
[PROGRAM//\]
PROGRAM
E3
To start using the Program Mode, you must first set the printer
Off Line, then press the [PROGRAM]
button. Within a pro-
A
gramming sequence, pressing the [PROGRAM] button takes the
;
=
programming
Menu to the next higher level, or exits from the
Program Mode and displays "PRINTER
READY". For details, refer to 3.3
Programming
from the Control Panel.
This printer keeps two types of user default settings: Mode 1 and Mode 2.
The Mode I is the normal default set on power-up or hard reset. You can
select either Mode I or Mode 2 by using [PROGRAM] button in normal Off
Line mode.
Pressing and holding this button for two seconds, the screen will display
"NO CHANGE".
Release the button and press it again. Now the screen will
display "MODE 1". If you release and press the button once more, "MODE 2"
is shown on the screen.
When you press the other button, the initial setting is changed to the
displayed mode setting.
[FEEDER SELECT]
-
-
-_..
--
-
This button controls from where the printer will expect paper
when printing. To change from one source to another, the
L-J
printer must be Off Line. press the [ON LINE] button if the ON
LINE LED is on, then hold down the [FEEDER SELECT ] button
for a while. The screen will display "FEEDER SELECT".
1) If the button is released while this message is displayed,
the screen
displays the current feeder selection (e.g. multi-purpose
tray). Further
presses will cycle through the options below:
Cassette Only
Auto Selection
Cassette
MP Tray
Manual Feed
Cassette Only
35
Advertisement
Table of Contents
